For customers using the open bag packaging machine, simply purchasing the equipment is not enough. Just like all mechanical equipment that requires regular maintenance, the packaging machine also needs daily cleaning, maintenance, and timely handling of simple malfunctions in order to be used for a long time and with stability.
Today, I’ll specifically talk about: how to clean and maintain on a daily basis and how to solve common malfunctions. Recommended collection, convenient access at any time.
25kg Powder Open Bag Packaging Machine


The materials processed by the open bag packaging machine are mostly in powder or granular form. During the operation, dust residue or material spillage is inevitable. If not cleaned in time, it will not only affect the packaging accuracy but also accelerate the wear of components and even cause safety accidents. Therefore, daily cleaning work must be done well.
Before leaving work everyday, the residual materials in the machine compartment and the dust on the scale body must be cleaned up. Clean the inside and outside of the machine regularly, including the conveyor belt, conveyor channel, packaging area, etc., to ensure that no dust, debris accumulation.
When the machine is not in use for a long time, in addition to the regular cleaning, it is necessary to wipe the entire machine clean, apply anti-rust oil to the smooth surfaces of the components, and cover it with a cloth cap. If this step is done properly, there will be no problem of “getting rusty” when the machine is turned on next time.
The equipment should be comprehensively inspected once a month, focusing on whether the moving parts such as worm gear, worm, bolts and bearings on the lubrication block can be rotated flexibly and whether there is obvious wear. If any defects are found, they should be repaired or replaced immediately. Do not “make do” – small problems left unaddressed for a long time can turn into major faults.
Regular lubrication. The transmission system of the equipment is the core component, and its operating condition directly affects the packaging efficiency. According to the instructions for use, regularly add lubricating oil to bearings, chains, gears, etc., to reduce wear and extend the machine’s lifespan.
Check the tension and position of conveyor belts regularly to ensure that they are not slack, broken or deflected.
Regularly check whether the wire is firmly connected to avoid short circuit or open circuit.
Regularly check that switches, sensors, motors and other components are working properly.
The metering and packaging control systems are regularly calibrated to ensure accurate weighing accuracy.
Fault 1: Incorrect Packaging Weight
Possible Causes:
Abnormality in the measurement system, requiring calibration
Sensor failure
Changes in material flowability and density, etc.
Large fluctuations in environmental factors such as temperature and humidity
Solution:
Calibrate the measurement system;
Check the connection and working condition of the sensors. If any damage is found, replace them.
When changing different materials, adjust the parameters of the packaging machine or use auxiliary equipment such as vibrators to ensure the uniform flow of the materials.
Fault 2: Excessive spray or dust during packaging
Possible Causes:
The bag clamping mechanism did not fully seal the bag opening.
The air source pressure was set improperly.
Solution:
Check if the bagging head is fully pressing down on the packaging bag opening. If bulging bags and large amounts of dust occur during automatic packaging, appropriately reduce the pressure of the fluidizing gas source.
Fault 3: The valve never closes when feeding.
Reason: There are no materials left in the large storage bin.
Solution: Switch to the clearance mode to package the last few packages of materials.


The open pocket packaging machine is not a particularly complex device. However, “three parts for use, seven parts for maintenance” – if daily cleaning is done properly, regular maintenance is not neglected, and small faults are dealt with promptly, the equipment can be used reliably for many years.
If you encounter a problem in the use of the equipment that is not covered in this article, please feel free to contact our technical support team, we will help you as soon as possible.